Facility Safety: Facility Safety

StairsKeeping buildings, machinery and premises safe is essential to the success of electronic component manufacturing facilities.

These common scenarios show typical safety hazards found in electronic component manufacturing facilities:

• A painted concrete floor becomes slippery around the production and assembly areas due to lubricant leaks from machinery

• A customer walks from the parking lot and trips and falls on loose asphalt

• Racking is installed without being secured to the wall and floor. Damage to a corner post by a forklift causes the racking to tip and collapse

These and other hazards may exist in your facility. You can help control and manage the insurance risks associated with facility safety by implementing these tips for electronic component manufacturers:

Facility Safety

• Define procedures by which employees promptly report fluid leaks from machinery and containers

• Establish a Preventative Maintenance schedule for each piece of machinery and critical-use equipment according to manufacturers’ specifications

• Mark paths of travel for forklifts, vehicles and pedestrians throughout the facility

• Install electrical wiring using trained electricians, in accordance with the National Electric Code’s NFPA 70 code

• Avoid congestion or bottlenecks when planning layout and spacing of machinery and equipment

• Store stock supplies a safe distance from machinery and general traffic areas

• Apply an etcher or other commercial floor surface treatment that maintains a safe coefficient of friction (.5 or higher) to ensure painted floors do not create risk of slip and fall injuries. Employees should wear non-permeable, slip-resistant soled shoes to prevent slipping.

• Post Personal Protective Equipment requirements at all production area entrances

• Do not allow employees to smoke, eat or drink in production areas

• Provide adequate lighting

• Assess the building exterior to determine if there is a need for rodent, pest or bird control measures

• Inspect floor coverings at entrances and hallways

• Meet all wiring needs by hardwiring instead of using extension cords

• Mark appropriate clearances around electrical panels, emergency exits, doors and sprinkler equipment

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: